About it
Bobbin Carousel 24 holds 24 pre-wound Class 15 bobbins on 12 pegs, two to a peg, with every colour in view. When you need the right thread mid-seam, you turn the turntable until it faces you.
Each peg is 33 mm long and takes two Class 15 bobbins, 20.3 x 11.7 mm each. The turntable sits on a 608 steel ball bearing in a base 108 mm wide. Assembled, it measures 140 x 140 x 46.6 mm, low enough to sit beside the machine. It goes together in three steps: press the bearing into the base, press the 12 pegs into the turntable, push the orange axle dot through the centre into the bearing.
Printed to order in Gray PLA, a plant-derived plastic, with an orange PLA dot at the centre. Designed and printed in Louisiana, checked by hand before it ships. Fits Class 15 bobbins. Not affiliated with any machine maker. For your sewing table, not a toy. Any printed part replaced free, for life.
PLA softens with heat, so keep it away from heaters, hot water, sunny windowsills and hot cars.